Xd100 xerox manual

Recommended environment: — Page Installation Installation As you unpack the WorkCentre, familiarize yourself with its contents. They should be used to repack the WorkCentre if it has to be shipped for servicing or in case you move. Remove the bag from the WorkCentre.

Page 16 Installation continued 6. Secure the paper tray button and the shipping screw in the locations shown. Turn the paper tray button to secure its storage position. Note: Save the paper tray button and the shipping screw. They will be needed if the WorkCentre has to be moved. Page 17 Vigorously shake the cartridge to loosen the toner. Thoroughly shaking the cartridge will assure maximum copies per cartridge.

Xerox has included a Starter Toner Cartridge. Purchased replacement toner cartridges will yield approximately three times the number of copies.

Page Control Panel Control Panel The control panel has keys and lights that are used to control and display the conditions of the WorkCentre.

Book Mode XD only : Select book mode when you want to make copies from a bound document. Page 19 Control Panel 7. Variable Percentage: Press the down key to decrease the percentage. Press the up key to increase the percentage. There are two modes of power reduction; Power Save, and Power Shut-off. Power Save Mode — Page Paper Specifications Paper Specifications Paper Storage Note: Paper affected by humidity, and curled paper can cause jams and copy quality problems.

For reliable copier operation and good copy quality, Xerox recommends that paper be stored: on a flat surface. Page Loading Paper Loading Paper will flash in the copy quantity display and the green indicator in the copier diagram will flash when: a paper tray is empty. If the paper has misfed, open the paper tray indicated by the flashing green light on the copier diagram and remove the misfed paper. Page Flashing Loading Paper Flashing When the Alternate Paper Tray runs out of paper, or the paper misfeeds, the P will flash in the display and the green indicator in the copier diagram will flash.

Ensure that the WorkCentre is Off-line. The light between the two icons will be off. Select the desired copy features from the control panel.

Select the number of copies. Press the 10 to increase the quantity by Ensure originals are in good condition, and that all staples and paper clips have been removed. Place the originals face up in the ADF. Select the features. The maximum copy quantity is 1. Not all appliances and electronics have Training Manuals. Supplements usually address changes in circuitry. The manual of the purchased cartridge usually contains the solution, if this does not work, it is advisable to contact the seller.

How come my prints are of poor quality? There can be various reasons for poor print quality. Check if the cartridges or toners are full. If so, inkjet printers often require cleaning the printer, the cartridges have dried out, or the print head is broken. With laser printers, calibrating the laser printer is recommended.

What is the difference between a laser printer and an inkjet printer? Related products. DIY Do-It-Yourself manuals are made for homeowners and handymen who have mechanical abilities but can use a little training in repairing certain appliances.

It is only to be used along with the service manual not as a replacement for it as it applies to the appliance type, not the specific model and will go into more details on repairing the appliance.